config t interface serial0 no shutdown After this, show ip interface brief still shows Serial0 down/down .
If you have ever fired up a Cisco router in Dynamips , GNS3 , EVE-NG , or Cisco Packet Tracer , you have likely seen the console output slowly crawl by until it halts at a seemingly concerning line: "Virtual device serial0 will start disconnected" For many students, this message triggers an instinct to panic. Is the router broken? Is the image corrupted? Will Serial0/0 ever come up? virtual device serial0 will start disconnected
Now go build your topology, connect those serial cables, and watch show interface serial0 finally display the glorious words: config t interface serial0 no shutdown After this,
[[router R1]] image = c7200.bin serial0 = "R2 serial0" This tells Dynamips to create a direct serial cable between the two virtual devices on boot. A common mistake is logging into the router and typing: Is the image corrupted
A: Because IOU/IOL images are binary-level simulations that run natively on Linux. They do not use the Dynamips virtual device layer. They treat serial interfaces as internal software constructs, not hardware emulations. Conclusion: A Feature, Not a Bug The message "Virtual device serial0 will start disconnected" is the emulator's honest way of telling you, "I have no information about what this port should connect to, so I am leaving it in a safe, disconnected state."
The short answer is: